VERSATILE CARBIDE BAND SAW BLADE WITH SET TEETH, SPECIFICALLY DESIGNED FOR SAWING MACHINES THAT ARE NOT OPTIMALLY EQUIPPED AND WHERE BIMETAL BAND SAW BLADES REACH THEIR PERFORMANCE LIMITS
• Carbide band saw blade with set teeth
• Increased kerf width thanks to a special tooth-setting pattern
• Cutting geometry with a defined M-SET tooth sequence
• Asymmetrical chip removal and dampened vibrations during cutting
• Versatile band saw blade for general-purpose cutting of mixed stocks of steels and alloys
• Suitable for machines that are not optimally equipped and where CT-SIGMA carbide band saw blades cannot achieve their full potential
• The right choice as an introduction to carbide technology on lower-performance machines
• Low cutting resistance
• Good surface finish
• Suitable for applications without the highest performance requirements, where cutting capacity is significantly limited by the machine
• Good results when cutting mixed stocks of tool steels and alloy steels at steel distributors and forging facilities
• Suitable for cutting quenched and tempered steels up to 300 HB or tensile strength up to 1,000 N/mm²
• Suitable for workpieces with difficult, scale-covered surfaces
• Cost-effective entry-level product that allows users to achieve a higher performance level than bimetal band saw blades
WIDTH x THICKNESS |
TPI (TEETH PER INCH) |
|||||
| mm | inch | 3/4 | 2/3 | 1,4/2 | 1/1,3 | 0,8/1 |
| 27 x 0,9 | 1-1/16 x 0,035 | • | • | |||
| 34 x 1,1 | 1-3/8 x 0,042 | • | • | |||
| 41 x 1,3 | 1-5/8 x 0,050 | • | • | • | ||
| 54 x 1,6 | 2-1/8 x 0,063 | • | • | • | • | |
| 67 x 1,6 | 2-5/8 x 0,063 | • | • | • | • | |
| 80 x 1,6 | 3-1/8 x 0,063 | • | • | • | ||
CONTACT LENGTH mm |
30-150 | 150-300 | 300-500 | 500-800 | 800-2000 | |
| CT-ALPHA® M-TH4 | CT-ALPHA® M-VX5 | |
| Construction steel, Automatic steel |  |
 |
| Carbon steel | |
|
| Hardened and tempered steel | |
|
| Hardened and tempered steel over 1200 N/mm² |  |
|
| Case-hardened steel, Spring steel | |
|
| Bearing steel | |
|
| Hot tool steel | |
|
| Cold tool steel | |
|
| High speed steel | |
|
| Ferritic stainless steel | |
|
| Austenitic stainless steel | |
|
| Martensitic stainless steel | |
|
| Duplex and heat-resistant steel | |
|
| Cast iron | |
|
| Nickel alloys | |
|
| Titanium alloys | |
|
| Aluminium alloys | |
|
| Copper alloys | |
|
| Aluminiumbronze | |
|
advised
suited
allowed
not expected
